How to Install the ConnectIT Mount Plate

July 27, 2016

The ConnectIT Mount Plate for the Tobii Dynavox T10 is easy to install. All you need to do is remove the screws from the back of your T10, position the mount plate, and then attach it using the two Phillips screws provided.

Included with the Connect IT Mount Plate are:

  • Hex-head Allen wrench
  • Two Phillips screws

Remove the Screws from the Back of the T10

Using the hex-head Allen wrench included with the mount plate, remove the two screws from the back of your T10.

Note: If you have previously attached the handle that was included with your device, you will need to remove it in order to use the mount plate.

kA1G00000008twbKAA_en_US_1_0

Position the Mount Plate

Position the mount plate on the back of your T10 as shown in the illustration below. Line up the screw holes in the T10 with the screw holes in the mount plate.

kA1G00000008twbKAA_en_US_1_1
Note: If the plate is positioned correctly (i.e., right-side up), the screw countersinks will be facing upward, and the notch at the top of the plate will be oriented to the left.

Attach the Mount Plate

Using a Phillips screwdriver (not included with the mount plate), screw the two provided Phillips screws through the holes in the mount plate and into the device.

Note: The specifications of the Phillips screws are: 8-32 x 1/2" flat-head machine screw, black oxide with NyLoc (Tobii Dynavox part # 140381).

kA1G00000008twbKAA_en_US_1_2